Operating Incidents - jbc JT 6040 Bedienungsanleitung

Soldering Iron 2010 for great precision tasks,
like SMD solders, etc.
Soldering Iron 2045 for general soldering
tasks in professional electronics.
These soldering irons have a wide range of
cartridges with different models of tips. The
cartridge 2045-009 and 2045-010 are
specially designed for soldering SMD circuits
of the QFP and PLCC types.
Solder wire with a diameter of between 0.5 and
0.7 mm should be used.
6 Depending on the nature of the component to
be soldered, use soldering paste together
with our hot air station JE 6050, which gives
very accurate air-flow regulation, between
1 and 9 l/min.

OPERATING INCIDENTS

The suction cup does not adhere to the
component.
Deficient aspiration, Vacuum.
1 Verify if the suction cup is well placed and in
perfect condition.
2 Verify the filters at the entrance of the pump,
and change them if dirty or obturated, therefor:
Disconnect the filter plug tube. Unscrew the
plug and remove the gasket.
Remove the three paper filters, throw away the
dirty ones and replace with new ones.
Insert the three filters and the gasket in this order;
screw-up the cover and connect the tube.
Check for air tightness.
Error messages
Whenever the ERR message appears, the
equipment turns itself off completely.
The following messages are displayed:
- BLANK SCREEN
Power failure.
Check for blown fuses.
- ERR 1
The temperature will not rise.
Possible causes: heating element open or blown
fuse.
- ERR 2
The temperature is rising out of control.
Possible causes: shorted triac or insufficient
airflow.
- ERR 3
No reading from the thermocouple.
Possible cause: open thermocouple.
- ERR 4
Erratic readings from the thermocouple.
Possible causes: the thermopar or its
connections are in poor condition.
5
ENGLISH