Description Of The Appliance; Installing The Appliance - EINHELL GS 4600 Bedienungsanleitung

Anleitung_GS_4600_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
CAUTION! DANGER!
The emissions from this appliance are dangerous if
they are allowed to accumulate. It is prohibited to use
the appliance in any inhabited rooms.

Description of the appliance:

Components: (Figure A)
1. Burner bracket
2. Radiator
3. Spring washer
4. Wing nut
5. Snug bolt
6. Gas pipe
7. Pressure regulator
8. Union nut
9. Safety tap
10. Knob
11. Clamping screw
12. Gas bottle valve
13. Bottle valve thread
14. Ignite here!
Features
A mobile gas radiant heater for use in uninhabited
rooms.
Technical data
Heat output: 4.6 kW - 2.7 kW (max.-min.)
Gas consumption: 336 g/h - 200 g/h (max.-min.)
Category:
Gas and pressure:
Nozzle code:
18.02.2010 13:55 Uhr
Important:
This appliance works with 5 kg and 11 kg bottles of
butane or propane gas that are fitted with a pressure
regulator (50 mbar) in accordance with the
specifications of DIN 4811-T1.
It is to be used with a standardized pipe in
accordance with the specifications of DIN/DVGW
4815-2, maximum length 50 cm.
The pipe and the pressure regulator can be
purchased separately.
This appliance is to be used only outdoors and only
for heating purposes.

Installing the appliance

Always use far away from flames, sparks or
combustible materials.
Fasten the burner bracket (1) to the appliance
using the snug bolt (5), the spring washer (3) and
the wing nut (4) (see Figure A).
The angle of the radiator can be infinitely adjusted
with the wing nut (4). Bottom and rear positions
are limited by a lug on the bracket.
Mounting the appliance on the gas
bottle
Place the appliance on the bottle so that the
projecting clamping screw (11) fits inside the front
open part of the bottle collar.
Tighten the clamping screw (11) so that the two
metal tips of the burner bracket (1) and the tip of
the clamping screw enclose the neck of the bottle
snugly, then tighten fully.
Tighten the clamping screw, making sure that
they also engage in the groove around the bottle
neck.
Slip the gas pipe (6) with self-cutting coupling on
the stub of the safety tap (9) and screw tight
(wrench 17 mm).
Screw the other end of the pipe tightly to the
pressure regulator (7) (wrench 17 mm).
N.B.: Left-hand thread.
Connect the union nut (8) of the pressure
regulator with the bottle valve thread (13) by
I 3 B/P (50)
turning anticlockwise. Turn the union nut by hand
butane gas 50 mbar
without the use of any tools or the bottle valve
propane gas 50 mbar
seal may be damaged and jeopardize leak-proof
0.90
operation.
Make sure there are no cracks in the pipe and no
contact between the pipe and the radiator (2).
Seite 7
GB
7