Whale DS0003B Bedienungsanleitung Seite 8

Note The valve should be installed as close to the housing as possible. Space must
also be allowed for the handset hose to be easily pulled out for showering and replaced
for stowage (See Fig. 2/Fig. 7).
Note In order to securely fasten the unit, ensure that the valve mounting surface is a
minimum thickness of 19mm (3/4").
STEP 2 Connect hot and cold plumbing into 1/2" threaded ports. If attaching to Whale
Quick Connect plumbing fittings, use two WX1532B fittings (provided in
retail packed models only, available separately for bulk packed models). (See
Fig. 13a and b).
STEP 3 Attach the shower hose to the
valve housing. Push in with long
stem entering the slot and then
rotate clockwise by 30 degrees to
the locked 'on' position
(See Fig. 14).
Note Ensure the hose is fully pushed in
for a secure connection.
STEP 4. Screw p clamp to bulkhead
ensuring it is located at least
300 mm (12") from the valve housing (See Fig. 14)
Note In order to securely fasten the unit, ensure that the p clamp mounting surface is
at least 19mm (3/4") minimum thickness.
STEP 5 Close all the faucets and showers. Then turn on the water pump and check all
the connections are dry. Test Whale Twist® operation (See section 10).
PLUMBING – COLD ONLY MODELS
Models: DS0211B, DS0212B, DS0005
STEP 1 Connect shower hose to plumbing -
(See Fig. 15).Connects directly to
Quick Connect Plumbing, use
WU1215 (included).
STEP 2 Screw p clamp to bulkhead ensuring it is located at least 300 mm (12") from
the valve housing (See Fig. 14).
Note In order to securely fasten the unit, ensure that the p clamp mounting surface is
at least 19mm (3/4") minimum thickness.
STEP 3 Close all the faucets and showers, turn on the water pump and check all the
connections are dry. Test Whale Twist® operation (See section 14).
Fig. 14
Fig. 15
8