Bahco BBT80 Handbuch Seite 6

English
actual volts and the actual SAE or %. {Press the◄ ►
key to select: SOH (STATE OF HEALTH) or SOC
(STATE OF CHARGE)}.
One of six results will be displayed:
GOOD & PASS :
The battery is good & capable
of holding a charge.
GOOD & RECHARGE :
The battery is good but needs
to be recharged.
RECHARGE & RETEST :
Battery is discharged, the
battery condition cannot be
determined until it is fully charged. Recharge & retest
the battery.
BAD & REPLACE :
The battery will not hold a
charge. It should be replaced
immediately.
BAD CELL & REPLACE :
The battery has at least one
cell short circuit. It should be
replaced immediately.
LOAD ERROR :
The tested battery is bigger
than 2000SAE or 200AH. Or
the clamps are not connected properly. Please fully
charge the battery and retest after excluding both
previous reasons. If reading is the same, the battery
should be replaced immediately.
- GB.9-V1 -
GOOD & PASS
××.××V ×××× SAE
GOOD & RECHARGE
××.××V ×××× SAE
RECHARGE & RETEST
××.××V ×××× SAE
BAD & REPLACE
××.××V ×××× SAE
BAD CELL & REPLACE
××.××V ×××× SAE
LOAD ERROR
10
13. Press «ENTER» to get TEST
CODE for record.
※ There will be BARCODE appearance after printing.
Please pay attention to BARCODE Scanner which
only supports CODE39 format.
※ What is the "Test Code"? How to use it?
1. Put the CD into CD or CD/DVD/BLUE RAY
combination drive.
2. Follow the installation instructions and install
the icon named "Decode_RT777WWVxx" and
the sheet below will pop up.
3. Input the "Test Code" into the chart manually
or by barcode scanner.
4. Test result will show up in the chart after
decoding.
5. The test data can be stored in the PC.
14. Press the ◄ ► key to select
result printing: YES or NO.
Press «ENTER» to confirm
your choice.
11
- GB.10-V1 -
English
CODE
xxxxxxxxxxx
PRINT RESULT? ◄► ↵
NO