Terms And Conditions Of Warranty - Bahco BBT80 Handbuch

English

TERMS AND CONDITIONS OF WARRANTY

Any battery tester defective in material or workmanship will be
repaired or replaced according to published defective return test
repair procedures. The existence of a defect shall be determined
by the seller in accordance with published procedures. The
published test procedures are available upon request.
This warranty does not cover any unit that has been damaged
due to accident, abuse, alternation, use for a purpose other than
that for which it was intended, or failure to follow operating
instructions. This warranty is expressly limited to original retail
buyers. This warranty is not assignable or transferable. Proof of
purchase is required for all alleged claims. Warranty cannot be
authorized without proof of purchase. Warranty claims must be
sent pre-paid with dated proof of purchase. Damage incurred
during shipment is the responsibility of the shipper (customer
returning unit) If the returned unit qualifies for warranty, the
shipper will only incur shipping cost. The seller reserves the right
to substitute or offer alternative warranty options at its discretion.
The sole and exclusive remedy for any unit found to be defective
is repair or replacement, at the option of the seller. In no event
shall the seller be liable for any direct, indirect, special, incidental,
or consequential damages (including lost profit) whether based
on warranty, contract, tort, or any other legal theory.
RETURN GOODS:
Pack with sufficient over-pack to prevent damage during shipment.
Damage incurred during return shipment is not covered under this
warranty. Repair costs for such damages will be charged back
to shipper.
REMARK:
WHEN RETURNING GOODS, PLEASE SHOW "RETURN
GOODS" ON ALL INVOICES & RELATED SHIPPING
DOCUMENTS TO PREVENT ANY EXTRA CHARGE."
- GB.21-V1 -
22
BBT80 PROBADOR DE BATERÍA Y ANALIZADOR DEL SISTEMA
ELÉCTRICO CON IMPRESORA PROCEDIMIENTO DE LA
PRUEBA / INSTRUCCIONES DE FUNCIONAMIENTO
IMPORTANTE
1. Para probar baterías de 6 y 12 voltios, y para probar el
sistema de carga de 12 y 24 voltios.
2. Se recomienda que el rango de temperatura durante la
prueba, esté entre 0° C (32°F) y 50° C (122° F)
Tapa Protectora
Abajo
Enter
Pantalla LCD
Papel de Impresión
Pinza Polo Negativo (NEGRO,-)
- E.1-V1 -
23
Spanish
Arriba
Pinza Polo Positivo (ROJO,+)