Bahco BBT80 Handbuch Seite 5

English
BRIGHTNESS
◄ ADJUST ► ↵
TEST COUNTER ↵
BATTERY/SYSTEM
TEST DISPLAY
6.
Press the ◄ ► key to select battery test. Press
«ENTER» button.
7.
Press the ◄ ► key to select
the battery type：
a. REGULAR LIQUID
b. AGM FLAT PLATE
c. AGM SPIRAL
d. VRLA/GEL
Press «ENTER» to confirm choice.
8.
Press the ◄ ► key to select
the battery rating： SAE, EN,
IEC, DIN or JIS
Press «ENTER» to confirm choice.
9.
Press the ◄ ► key to input
the battery capacity of SAE：
• SAE：40~2000
- GB.7-V1 -
"Hour"& "Minute"
setting. After
finishing "Minute"
setting, press
«ENTER» to
battery test
Press «ENTER» to
confirm the
brightness setting
Press ◄ / ► to
adjust the brightness
of the display. Press
"Enter" to confirm the
brightness & go back
to battery test.
Press «ENTER» to
see how many times
you tested in
battery/system test.
Example :
BATTERY TYPE ◄► ↵
AGM FLAT PLATE
SELECT RATING ◄► ↵
SAE
SET CAPACITY ◄► ↵
×××× SAE
8
• EN：40~2100
• IEC：30~1500
• DIN：25~1300
• JIS：By Battery Type No.
Press «ENTER» to begin the test.
Surface Charge Notice
The battery will hold a surface charge if the engine has
been running or after the battery has been charged. The
tester may prompt you to remove the surface charge.
a. Follow the instructions indicating when to turn
the headlights on and off or apply a load into
the battery.
In Vehicle
SURFACE CHARGE TURN HEADLIGHTS
IN VEHICLES? YES
ON FOR 15 SECS
Out of Vehicle
SURFACE CHARGE TESTING
IN VEHICLES? NO
b. The tester will resume testing after it detects
that the surface charge is removed.
10. Test the battery for few
seconds.
11. Press the ◄ ► key to select
battery fully charged or not if
tester asks. Press «ENTER»
to confirm choice.
12. When the test is completed, the display shows the
9
- GB.8-V1 -
English
TESTING
IS BATTERY ◄► ↵
CHARGED? YES