Jamie Oliver Classic 3S Gebrauchsanweisung Seite 17

Lighting instruction side burner (if applicable)
1.
Once the grill burner has been lit, the side burner can be lit by following the instructions below.
2.
Open the side burner lid before lighting the side burner and turn the side burner control knob to the 'O' position.
3.
Push down the side burner control knob and keep pressing whilst turning anti-clockwise to the full rate position, an audible
click will be heard, this will light the burner. If the burner does not light, repeat this process.
4.
If the burner has not lit after two attempts, turn OFF the gas tap, wait 5 minutes and then repeat step 3 in main burner lighting
instructions.
5.
When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise to any position between the full
and low rate position.
6.
To turn the barbecue side burner off, turn the cylinder valve or regulator switch to the 'O' position and then turn all of the control
knobs on the barbecue clockwise to the 'O' position until the flames have been extinguished
Warning: If the burner fails to ignite, turn the control knob to the 'O' position (clockwise) and also turn the cylinder valve off. Wait five minutes
before attempting to relight with ignition sequence. Never bend over the grill when lighting it.
Lighting instruction infrared burner (if applicable)
1.
Once the grill burner has been lit, the infrared burner can be lit by following the instructions below.
2.
Open the infrared burner lid before lighting the infrared burner and turn the infrared burner control knob to the 'O' position.
3.
Push down the infrared burner control knob and keep pressing whilst turning anti-clockwise to the full rate position, push the
infrared burner ignitor to light the burner. If the burner does not light, repeat this process.
4.
If the burner has not lit after two attempts, turn OFF the gas tap, wait 5 minutes and then repeat step 3 in main burner lighting
instructions.
5.
When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise to any position between the full
and low rate position.
6.
To turn the barbecue infrared burner off, turn the cylinder valve or regulator switch to the 'O' position and then turn all of the
control knobs on the barbecue clockwise to the 'O' position until the flames have been extinguished
Warning: If the burner fails to ignite, turn the control knob to the 'O' position (clockwise) and also turn the cylinder valve off. Wait five minutes
before attempting to relight with ignition sequence. Never bend over the grill when lighting it.
Cleaning and care
ATTENTION: All cleaning and maintenance should be carried out only when the barbecue is cool and not connected to the gas cylinder.
Cooking grid
"Burning off" the barbecue grill bars after every use (for approx. 15min) will keep excessive food residues to a minimum. A barbecue cleaning
brush to removes food residues from the cooking grid. Use mild soapy water and a soft sponge to remove stains and other particles, rinse with
water. After cleaning apply a little plant oil to the cooking grid, using a paper towel, this will prevent corrosion on the cooking grid.
MAIN BURNER
17
UK