BOMANN GS 176 NoFrost Gebrauchsanweisung Seite 21

Socket driver (8 mm), (10 mm)
Cross-shaped screwdriver
Putty knife or thin-blade screwdriver
1) Remove the three screws at the rear and the two
screws at the top of the Larder Freezer and remove
the lid.
2) Use an 8 mm spanner to remove the top bracket.
3) Lift the hinge bracket out of the recess in the door.
4) Remove the pin from the bracket with a 10mm
spanner/socket. Replace in the same hole
through the other side. Remove the door.
5) Lay the Upright Freezer backward. Remove
the bottom hinge bracket using an 8 mm socket or
spanner.
6) Remove the pin and replace on the opposite side.
Using a 10 mm socket or spanner.
Reattach bottom bracket to the Upright Freezer. Re-
place leveling feet. Stand upright and replace door.
7) Insert top hinge bracket into the recess on top of the
door. Bolt into place using the three bolts removed earli-
er.
8) Remove blanking plates from the door handle to
reveal screws. Remove the two screws that secure the
handle,
7
03/2012