RF Player RF P1000 Installationsanleitung Seite 23

Warning! The very common error is to put the RF source too close to RFPLAYER during learning.
Click on «Transmit RF Frame» to verify that a good capture has been done at learning phase.
EN
OPTION OF TRANSCODING
Transcoding consists of translating the frames from one protocol to another. It is allowed here to
translate the first 32 PARROT IDs to a destination protocol. Please mark here this protocol, destination
IDs, (with specifying 'G' for example, ID 'A/B' Of PARROT will be translated to the 'G/H' IDs of the
chosen protocol), as well as its Qualifier.
Save then or remove the transcoding.
Note: The configurator can send transcoding values to RFPLAYER but cannot read this information
from RFPLAYER.
23
user guide RF P1000 v1.0 - www.rfplayer.com