RF Player RF P1000 Installationsanleitung Seite 20

CHOOSE THE RECEPTION SENSITIVITIES
It is usual to choose the highest sensitivity.
However, If the light is continuously blinking blue, it turns out that the environment is too noisy, it is
EN
recommended to decrease the sensitivity.
The sensitivity is here a trigger threshold that is expressed in decibels.
A value of 6 dB corresponds to a maximum sensitivity.
A value of 20 dB corresponds to a minimum sensitivity.
NOTE FOR MAXIMUM SENSITIVITY:
1. Do not put the antennas parallel! But rather with an angle of 70∞ to 180∞ from each other,
2. Do not put the antennas against surfaces made of metal, wood etc ... A plastic stuff is acceptable
3. Put RFPLAYER and its antennas far from other electrical devices.
CHOOSE THE RFLINK DECODING SENSITIVITIES.
If you are not using RFLINK and PARROT, you can set the value to '0'. Otherwise, set a quantized
value as for the receiving sensitivity described above.
LED SIGNALING:
BLUE: The LED lights blue when any RF signal is received. This can be useful information or noise.
PINK: The LED lights up in pink when a frame is recognized and decoded.
RED: The LED lights red when a frame is transmitted.
20
user guide RF P1000 v1.0 - www.rfplayer.com