Replacing The Jaws In The Jaw Case; Optional Accessories - Makita DRV150 Betriebsanleitung

5. Install the jaws to the jaw case.
► Fig.15: 1. Jaw 2. Jaw case
NOTICE:
When installing the jaws, be sure to
align the tips of jaws.
6. Install the jaw case. If the grease is adhered to the
tips of the jaws, wipe off the grease with a dry cloth.
► Fig.16: 1. Area where grease should not to be
adhered 2. Jaw
7.
Install the head assembly.
8.
Wipe off the grease from the jaws.
Insert a rivet into the nose piece, then move it up and
down, and left and right, then remove it from the nose
piece, and then wipe the grease from the rivet with a dry
cloth. Repeat the same procedure twice or 3 times.
NOTICE:
If the grease is adhered to the tip
or inside of the jaw, the jaws may slip during
operation.

Replacing the jaws in the jaw case

If the jaws in the jaw case are worn out, replace them
with new ones. To replace the jaws, follow the same
procedure for cleaning the jaws and jaw case. When
installing jaws to the jaw case, install new jaws.
Removing jammed rivet
If the rivet is jammed inside the tool, remove it using a
tool such as pin. If it is difficult to remove the jammed
rivet, replace the jaw pusher or pipe with a new one.
For replacement procedure, refer to the instruction for
installing or removing the head assembly.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Nose piece
• Jaw pusher
• Jaw
• Pipe
• Grease
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
9 ENGLISH