Makita DRV150 Betriebsanleitung Seite 7

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing the head
assembly
To remove the head assembly, follow the steps below.
1. Loosen the nut of the head, and then remove the
head.
► Fig.5: 1. Nut 2. Head
2. Loosen the nose piece with a wrench while hold-
ing the head with another wrench.
► Fig.6: 1. Nose piece 2. Head
3. Loosen the jaw case with a wrench while holding
the joint with another wrench.
► Fig.7: 1. Jaw case 2. Joint
4.
Remove the jaw pusher, spring, and pipe.
► Fig.8: 1. Jaw pusher 2. Spring 3. Pipe
NOTICE:
When installing the jaw pusher, be sure
to attach the spring to the jaw pusher.
To install the head assembly, perform the removal pro-
cedure in reverse. Be sure to tighten the jaw case and
nose piece with two wrenches firmly.
OPERATION
CAUTION:
Keep your hand or face away from
the front part of the tool. The rivet or broken off
mandrel may accidentally ejected, and you may be
injured.
Installing a blind rivet
CAUTION:
Before the mandrel container
becomes full, empty it regularly by removing the
mandrel container. Otherwise, the tool may be dam-
aged, and the damaged parts may cause an injury.
CAUTION:
When inserting a blind rivet into
the nose piece, be sure to switch off the tool.
Otherwise, you may be injured with the tool tip.
CAUTION:
Do not the leave a blind rivet in the
nose piece. If the tool is switched on accidentally, the
blind rivet is ejected and may cause an injury.
Hook
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
CAUTION:
When hanging the tool with the
hook, hang it carefully. Otherwise, the tool may drop
and cause an injury.
► Fig.9: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing or removing the mandrel
container
NOTICE:
Be sure to install the mandrel container
to the tool before operating the tool. If the man-
drel container is not installed to the tool, the tool
will not operate.
To remove the mandrel container, rotate it counter
clockwise. To install the mandrel container, rotate it
clockwise.
► Fig.10: 1. Mandrel container
NOTICE:
After installing a blind rivet, be sure
to eject the broken off mandrel into the mandrel
container by tilting the tool backward before
installing next blind rivet. If the end of the broken
off mandrel sticks out from the nose piece, switch
off the tool and remove the mandrel. Otherwise,
the broken off mandrels may become clogged and
cause a malfunction of the tool.
1. Insert the blind rivet into the nose piece.
► Fig.11: 1. Blind rivet 2. Nose piece
2.
Press the tool tip against the workpiece, and then
pull the switch trigger. After the mandrel is broken off,
release the switch trigger.
► Fig.12
Before the mandrel container becomes full, empty it
regularly by removing the mandrel container.
7 ENGLISH