Maintenance Instructions - Desoutter EAD Serie Bedienungsanleitung

English

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task: disconnect the
tool.
● When disassembling / reassembling the tool,
take the following precautions:
- Check that the controller is switched off.
- Disconnect the cable.
● When disassembling the tool electronics, take
extra care for the wires when pulling out the
connectors.
● Check that components are in good condition
and apply grease on mechanical parts every
500,000 tightening cycles.
● Any repair on the electric motor, the resolver
card or the memory card shall be carried out
in our workshops or by trained and qualified
personal.
● When disassembling the tool front assemblies,
take care for the torque transducer wires.
When disposing of components,
lubricants, etc ... ensure that the
relevant safety procedures are carried
out.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
09/2019 13 / 78
6159932570_26