ASROCK Z97 Extreme6 Bedienungsanleitung Seite 30

1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Chassis and Power Fan
Connectors
(4-pin CHA_FAN1)
(see p.1, No. 16)
(3-pin CHA_FAN2)
(see p.1, No. 29)
(3-pin CHA_FAN3)
(see p.1, No. 34)
(3-pin PWR_FAN1)
(see p.1, No. 6)
CPU Fan Connectors
(4-pin CPU_FAN1)
(see p.1, No. 2)
(3-pin CPU_FAN2)
(see p.1, No. 3)
28
GND
+12V
CHA_FAN_SPEED
FAN_SPEED_CONTROL
GND
FAN_VOLTAGE
CHA_FAN_SPEED
GND
FAN_VOLTAGE
CHA_FAN_SPEED
4
FAN_SPEED_CONTROL
FAN_SPEED 3
+ 12V
2
GN D
1
FAN_SPEED
FAN_VOLTAGE
GND
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
This motherboard pro-
vides a 4-Pin CPU fan
(Quiet Fan) connector.
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.