Maintenance; Operation - SIOUX SPS10P18 Bedienungsanleitung Und Teileliste

For maximum performance and tool life, an air line lubricator, set to deliver 2 drops per minute, is recommended. SIOUX No. 288 Air Motor Oil is
recommended.

MAINTENANCE

Water, dust and other airline contaminants can cause rust and vane sticking. For long periods between tool use, flush the tool with a few drops of oil
and run for 10 seconds. This will help remove contaminants and reduce the formation of rust.

OPERATION

To install a sanding disc:
1. Install the 4 1/2 (114.3 mm) backing pad on the spindle. The 3" (76.2 mm) backing pad can be installed behind the 4 1/2 (114.3 mm) for additional
rigidity. DO NOT USE THE 3" (76.2 mm) BACKING PAD WITHOUT THE 4 1/2 (114.3 mm) BACKING PAD!
2. Install the sanding disc.
3. Install the retaining nut.
4. Insert the lever into the hub.
5. Turn the sanding disc by hand to tighten.
Start the tool by depressing the trigger.
Maintain a slight angle between the sanding disc and the work.
Do not use excessive pressure. Excessive pressure will cause the tool to slow down. Sanders work best at higher speeds.
Catalog Noise (Tested in accordance with ISO Standard 15744)
Number
Sound Pressure (dBA)
SPS10P18
SPS10P6 TBD
Form ZCE780A
Always remove the tool from the air supply be for installing or changing sanding discs!
NOISE AND VIBRATION READINGS
Sound Power (dBA)
80 91.6
TBD
WARNING
Uncertainty (dBA)
0.3
TBD
3
Vibration (Tested in accordance with
ISO Standard 28927-1:2009)
Vibration m/s Uncertainty m/s
2
Less than 2.5
TBD
Date 2016August11/D
2
0.3
TBD