Maintenance; Operation - SIOUX SAS series Bedienungsanleitung

LUBRICATION
All models may operate without airline lubrication. However, operating the tool without airline lubrication may reduce tool performance and vane life.
If an airline lubrication is not used, it is recommended that the tool be oiled daily before use to improve performance. Add 2-4 drops of air motor oil and
run the tool for 10-20 seconds to distribute oil through the tool.
For maximum performance and tool life, an air line lubricator, set to deliver 2 drops per minute, is recommended. SIOUX No. 288 Air Motor Oil is
recommended.
Do not over lubricate because excess oil may contaminate the surface being sanded.
For Angle Head
Lubricate the angle head assembly with 2 shots of SIOUX #1232 grease every 8 working hours.

MAINTENANCE

Water, dust and other airline contaminants can cause rust and vane sticking. For long periods between tool use, flush the tool with a few drops of oil
and run for 10 seconds. This will help remove contaminants and reduce the formation of rust.

OPERATION

The tool is equipped with a locking type lever in order to prevent accidental start-up.
Speed of the tool may be adjusted by turning the regulator, which is located opposite the throttle lever.
The angle head can be repositioned by loosening the retaining collar and positioning the angle head in the desired position and retighten the retaining
collar.
INSTALLING SANDING DISC (5/8"-11 Thread Models)
• Thread backing pad onto spindle.
• Place sanding disc over spindle and seat against backing pad.
• Thread disc retainer onto spindle and tighten
Catalog Noise* (Tested in accordance with ISO Standard 15744)
Number
*Sound Pressure (dBA)
SAS10S125 82.0
SAS10A125 83.8
SAS10AX125 83.2
SAS03S122-20
SAS03S202-20
SAS05S232-20
SAS10S182-20
Form ZCE801
WARNING
Always remove the tool from the air supply be for installing or changing sanding discs!
NOISE AND VIBRATION READINGS
*Sound Power (dBA)
93.6
95.4
94.8
Uncertaintity (dBA) *Vibration m/s^2
3.0
3.0
3.0
3
Spindle
Backing Disc
Sanding Disc
Disc Retainer
Vibration* (Tested in accordance with
ISO Standard 28927-3:2009)
Uncertaintity m/s^2
3.3
7.4
4.0
Date 2011December5/D
0.1
0.1
0.2