Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Message or code
Loaded paper is too wide. Manual unload required.
Paper too far from lateral load line. Please try again.
Please manually unload roll paper and try again.
Single sheet is loaded with too much skew. Press Eject to
unload paper.
The current job has been cancelled because the roll is out of
paper. Load the roll and send the job again.
You are printing a multipage job. Load another sheet to
continue printing or cancel the job.
Multi-sheet tray is out of paper. Load paper in multi-sheet
tray and press OK to continue printing or cancel the job.
End of roll has been reached. It is not possible to load the roll.
Missing or failed printhead
Refilled or depleted cartridge detected
Used cartridges might not have enough ink to complete
startup. Open ink door to replace the cartridges.
Wrong file format
Out of memory
01.1:10
02:10
03.0:10
08:10, 11:10, 17:10
21:10
21.1:10
41:10, 41.1:10, 42:10, 42.1:10, 45:10
51.1:10, 55:10
79:04
85.1:10, 85.2:10
4
Introductory Information
Recommendation
Remove the paper manually and load paper of the correct
size.
Remove and reload the paper.
Rewind the roll manually.
Remove and reload the paper.
Load a new roll.
Load another single sheet.
Load paper into the multi-sheet tray.
Load a new roll.
Remove and reinsert the same printhead, or try cleaning
the electrical connections. If necessary, insert a new
printhead.
Note:
The error message does not permit returning to the
home screen to start the printhead replacement. Instead,
press
Show
more.
Check the cartridge.
A new printhead has been inserted without a new set of ink
cartridges. Replace the cartridges not marked as new.
The file format is incorrect or not supported. The printer
cannot process the job, which will be discarded.
The printer cannot complete the job. Resend the job,
selecting
Send job as bitmap
Advanced
tab, then
Document options
Restart the printer.
There may be a paper or carriage jam. Check and clear the
paper path if necessary.
The battery of the real-time clock has expired; contact HP
Support.
Restart the printer.
There may be a paper or carriage jam. Check and clear the
paper path if necessary.
Restart the printer.
There may be a paper or carriage jam. Check and clear the
paper path if necessary.
Restart the printer.
Restart the printer. If the problem persists, update the
firmware.
Restart the printer.
in the driver: go to the
>
Printer
features.
Werbung
