Product Description - DOSPEL KOM II 400 Bedienungsanweisung

Product description

Thank you for the purchase of our product. We believe that it
will fulfill all your expectations. We wish you trouble-free
operation and satisfaction with the choice made. We
encourage you to share with us all comments you have
concerning the product and our company. We are awaiting
your comments at the phone number +48 34 370 30 00
extension III. You may also direct them to us via electronic
mail to the following address: serwis@dospel.com.
DOSPEL Sp. z o.o. wishes to present you the KOM fans family.
These are fireplace fans adapted for transportation of warm
air to the heated rooms. They are produced in the following
versions: KOM II 400, KOMII 600, KOM II 800. Furthermore,
an option with an additional bypass is available: KOM III 400
by-pass, KOM III 600 by-pass and KOMIII 800 by-pass.
APPLICATION: KOM warm air distributor is a part of the
fireplace heating system. It can transport warm air of up to
150°C to the heated rooms. High pumping pressure
balances the pressure drop in the installation ducts,
allowing distribution of warm air to several rooms at the
same time. KOM fans do not require frequent and detailed
inspections*. They are adapted to continuous work, in the
temperatures from -20°C to +150°C. Smoothly adjustable
KOM fan activation threshold temperature enables
temperature in the rooms to meet the user's individual
requirements. KOMs have a possibility of cooperation with a
circuit, allowing change of the fan rotation speed.
*Depending on the conditions prevailing at the fan operation place, but
not less frequently than once a year.
Construction:
KOM fan consists of:
• single-phase asynchronous motor with start-up condenser
and thermal fuse -suitable for continuous work S-1,
• radial turbine, mounted on the rotor axis,
• thermostat with the scope of activation threshold
temperature adjustment from 25°C to 90°C,
• casing made of galvanized steel sheet, resistant to
corrosion and mechanical damage, insulated with mineral
wool.
Installation:
After unpacking the fan, the following must be checked: •
condition of power supply cable (insulation cuts, cracks) •
condition of fan casing (dents, deformation) - the turbine
should not scrape the nozzle
Exploitation:
It is recommended to perform the aforementioned
operations because of any possible damage caused
during transport. If none of the aforementioned defects
was diagnosed, installation of the fan can begin at the place
of destination.
• The surface designed for the KOM fan must be levelled.
• KOM fan should be placed on a bed made of mineral wool
and rigid non-flammable material (plaster board measuring
50 cm x 50 cm) in order to absorb vibrations
• Set the air nozzle towards the distributing network to
optimize the length of network channels
• Install one or more decompression or transfer gratings in
the hood
• The warm air distribution system should be made of
flexible aluminum ducts, type
* Depending on the conditions in the fan's workplace.
TERMOFLEKS :
TERMOFLEKS type ducts mustn't be used for connecting the
KOM fan with the fireplace flue!!!
• Drill a hole in the ceiling with diameter slightly greater than
the diameter of feeding
• Set the warm air pipe inlet 10 to 20 cm below the
decompression grating or gratings of the hood
• The supply duct should be stretched and cut to size as
necessary for connection with the KOM fan
• The warm air supply duct that goes outside the hood must
be insulated with mineral wool
test
6
EN