Bestway 58486 Gebrauchsanleitung Seite 5

Assembly (You will need a screwdriver.)
1. Carefully remove all components from the package and check to
ensure nothing is damaged. If equipment is damaged,immediately
notify the retailer from where the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and Control Valve
are accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically
fixed on ground or a certain pedestal made of wood or concrete before use to prevent the
sand filter from accideutally falling. Fully assembled sand filter will exceed 18kg. The
mounting holes should be 8mm in diameter and spaced 86mm apart. Use two bolts and
nuts with a maximum of 8mm in diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand/Flowclear™ Polysphere.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 36kg bag should suffice.
If you do not use the recommended size of filter sand, filtering performance will be reduced
and thesand filter may damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom
Tank to submerse the Skimmer on the Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg (2.20 lbs) sand.
C
5
Ф8mm
4
MAX.
MIN .
MAX
MIN
C
86mm
C