Emos EM170 HD Gebrauchsanleitung Seite 8

• If Enabled, set the Time for turning off to the desired value. The receiver will automatically turn off
at the set time every day.
Options
• [OSD language]: Use the / buttons to select the language for on-screen display of menus.
• [Subtitle language]: Use the / buttons to select the language for subtitles.
• [Audio language]: Use the / buttons to select the default audio track for your programmes
• [Digital audio]: Use the / buttons to select the required digital output for audio.
a. <PCM>: Audio decoding will be done by the receiver with stereo output.
b. <RAW HDMI On> Intended for decoding the signal outside the receiver (by e.g. AV Receiver).
c. <RAW HDMI Off>: Does not transfer audio signal through HDMI interface.
• [AD story description]: Sets the volume for complementary audio track with story description for
the visually impaired (off – 31)
• [Auto hide OSD]: Set the duration of information window display after switching between channels.
System Settings
Press the / button to select.
• [Parental control]: Press the OK button to select age category.
• [Set password]: Press the OK button to confirm password.
• [Factory settings]: Press the OK button to reset to factory values.
• [Information]: Press the OK button to learn information about the receiver, SW and HW version.
• [Firmware update]: You can select SW update via USB.
• [Network settings]: Set up network connection.
Parental Control
• <Enter password>: Default 000000
• Change the age category by pressing the / buttons. Proper functioning is dependent on the
TV broadcast provider.
• Confirm by pressing the OK button.
Set Password
• [Enter old password]: Enter original numerical password.
• [Enter new password]: Enter new numerical password.
• [Confirm password]: Again enter the new numerical password to verify.
• Confirm by pressing the OK button.
Factory Settings
• <Enter password>: Default 000000
• Press the OK button to reset the receiver to factory settings (all settings made on the device will
be erased).
• If you wish to leave the factory settings window without resetting, press the EXIT button.
Information
Press the OK the view information about the model, software and hardware. Leave by pressing the
EXIT button.
Update Firmware
• <OAD>: This function is unavailable.
• <Update via USB>: See procedure below.
<Update via USB>: Select file and confirm with OK.
a.
b. Press the EXIT button to leave.
Network Settings
Set up a network based on local conditions (DHCP, static).
USB
• [Multimedia]: Press the OK button to select multimedia (Music, Photo, Film and PVR).
• [Photo settings]: Press the OK button to set parameters for viewing photos.
• [Film settings]: Press the OK button to set parameters for playing video files.
• [PVR configuration]: Press the OK button to set parameters for your PVR recordings.
• [Network applications]: Display interactive applications using Internet connection.
8