Emos EM170 HD Gebrauchsanleitung Seite 7

TV Format
If the image does not display correctly, you can change the following settings by changing the standard.
• [NTSC]: For American NTSC standard
• [PAL]: For European PAL standard
Video Output
The following option is available only for connection via SCART.
• [RGB]: For analogue separation of the three colour components of RGB.
• [CVBS]: For analogue merging of colour components into a single channel.
Channel Tuning
To enter the tuning menu, press the MENU button and then select the Channel Tuning tab using the
/ buttons.
This menu offers options for tuning channels for TV broadcast reception.
Automatic Tuning
This option automatically searches the entire broadcast band and automatically saves all channels found.
All previously saved channels will be automatically erased.
• Select [Automatic Tuning] and press the OK button. The receiver will immediately begin searching.
• To stop the search, press the EXIT button. All channels found before the button press will be
automatically saved.
Manual Tuning
This option allows searching for station on a specific channel if you do not want to search the entire
channel spectrum. Manual search will not erase previously found and saved channels.
• Select channel number using the / buttons. The frequency in MHz will be automatically shown
for each channel and it cannot be changed.
• Pressing the OK button will begin search on the selected channel.
• If a TV channel is successfully found, it will be saved automatically.
Setting Country of Use
Set the country in which you will be using the receiver, or another closest.
Antenna Power Supply
• If you are using an antenna with a built-in amplifier and +5 V power supply voltage, turn on this
function.
• If you are using a passive antenna or an active antenna with power supply voltage +12 V, use a power
adapter and turn off this function in the menu; otherwise, the device will be damaged or destroyed.
Time
Time Difference
[Time Difference]: Using the / buttons, you can change between automatic and manual setting.
• <Automatic>: Mode is chosen by the device from the TV signal.
• <Manual>: You choose time and date (can affect incorrect display in EPG).
• In manual selection, you then choose [Date] and [Time].
Sleep
The function automatically turns off the receiver after a chosen time limit.
By default, the function is off; can be set in hourly intervals from 1 to 12 hours.
Summer Time
For correct time settings, select whether your country uses summer time.
On / Off
This function allows you to choose the time when you want the device to automatically turn on and off.
• [On]: Use the / buttons to select whether you want to Disable or Enable the automatic ON
function.
• If Enabled, set the Time for turning on to the desired value. The receiver will automatically turn on
at the set time every day.
• [Off ]: Use the / buttons to select whether you want to Disable or Enable the automatic OFF
function.
7