Emos EM170 HD Gebrauchsanleitung Seite 3

SAFETY WARNING:
1. In order for the device to serve long and reliably, do not expose it to extreme temperatures or
high humidity. For instance, never put it in places intended for bathing or within proximity of
heat sources.
2. If the device does not work correctly, please take it to the nearest service centre. Do not attempt
to repair it yourself.
Warning for Use of USB Devices
To fully make use of the USB port, the storage connected to it must support standard
USB 2.0. For flawless, stable recording and play, USB devices with writing speed 9.0
MB/s or faster are required. Slower hard drives and flash storage may have problems
with recording which will manifest themselves by image freezing, or may not work at all. Proper func-
tioning can be expected only using drives with one basic partition with file system NTFS or FAT32. If a
different file system is present on the drive, format the drive on a PC to the recommended file system
before connecting it to the receiver.
Strongly fragmented or overfilled storage devices also may not work properly and smoothly.
External HDDs must have their own power supply, the USB port built into the receiver is not capable of
supplying sufficient voltage to power a portable USB drive.
While recording or playing, the USB device must not under any circumstances be disconnected from
the receiver. Disconnection while the receiver is working may cause damage to the receiver or the flash
drive and also damage the data located on the medium.
Standby
The receiver has a function of minimum power consumption in standby mode and is therefore more
friendly to the environment.
Firmware
The control software for this receiver is constantly in development. A new version of the software may
change some functions and operation of the receiver. Images and descriptions in this manual are only
informative in nature. If you notice an error, please inform us. We will do all in our power to correct it.
Receiver Connection and Control Elements:
1.
2.
Front and Rear Panel of the Device
Front Panel
• LED DISPLAY: Shows the number of the currently selected channel
Rear Panel (Fig. 1)
• RF input: Connector for antenna connection
• RF OUT: Output loop for connecting another device
• HDMI: HDTV digital output
3