Remote Control; Receiver Operation - Emos Em170 Hd Gebrauchsanleitung

• Coaxial: Digital audio output
• TV Scart: Analogue A/V output for connecting an older type of TV

Remote Control

• STANDBY: turn the receiver on/off
• MUTE: immediately mute audio
• EPG: Electronic programme guide
• INFO: show information about the current channel
• TTX: Teletext
• AUDIO: select audio track
• REC: instant recording button
• SUB-T: show DVB-T subtitles (is they are broadcast)
• MENU: show the main menu
• CH+/-: next/previous channel
• EXIT: back, exit menu
• VOL-/+: reduce/increase audio track volume
• OK: select menu item, show list of channels
• FAV: show list of favourite channels
• TV/RADIO: switch between list of TV/radio channels
• 0-9 (Numeric buttons): direct access to channel presets
• RECALL: return to previous menu
• GOTO: direct jump to the selected time in the recording, video
• REW: quick rewind
• FWD: fast forward
• PREV: previous file
• NEXT: next file
• PLAY: play file
• PAUSE: pause play
• STOP: stop play
• REPEAT: repeat play

Receiver Operation

The ensure sufficient ventilation and cooling, use the receiver in horizontal position. Do not place heavy
objects onto the receiver and do not cover it. Do not place the receiver into closed cabinets or places
with high air humidity.
Connecting the Receiver to TV (Fig. 2)
Connect the receiver to your TV using the appropriate cable in accordance with Figure 2. If your TV
is equipped with HDMI input, use this connector to enable watching TV broadcasts in the highest
image quality.
Receiver Installation and Controls
• After properly linking the TV and the receiver and connecting the antenna, turn on the TV and make
sure the receiver is connected to power supply. Turn on the receiver by pressing the STANDBY
button. If you are turning on the receiver for the first time or you set it to factory settings, the screen
will show an installation guide menu.
• You can move inside the menu using the / buttons.
• Use the OK button to confirm your selection.
• Use the EXIT button to go back or end.
OSD Language
Use the / buttons to select language for the receiver.
Country
Set the country where you will be using the receiver using the / buttons.
4