Description Of The Display - Ravelli Rbh 150 V Bedienungs- Und Wartungshandbuch

Handheld touch radio initialization
In order to operate correctly, the handheld set should be interfaced with the electronic board installed inside the stove. For this reason, on display
appears the following message:
If the handheld set is used for the first time, select YES using the selection keys and confirm with the dedicated key.
On the display of the handheld set appears the following:
Hold down for a few seconds the button of radio communication (RADIO ADJ) of the PCB, to initialize the device.
By pressing the enter key on the handheld set, the components start communicating with each other. A check sign on the display,
accompanied by a sound signal, shows that the initialization of the handheld set has been completed sucessfully
When you replace the batteries, you do not have to run the initialization procedure of the handheld set. In this case, when
on display appears the message "FIRST INSTALLATION ?", select NO and press the confirmation key.

Description of the display

The display of the handheld set is described below (in stand-by mode):
After 5 minutes of inactivity, the display of the handheld set turns dark, switching to "SLEEP" mode, while maintaining the
radio connection with the stove. By pressing the key ON/OFF, the display becomes active again.
The first pressure of any key with the display active, lights up its backlight, but it is not, however , considered a command.
Use and maintenance manual RBH 150 V- RBH 200 V
Page 72
1
2
Rev.1 14/02/18
EN