Cisco Linksys NSLU2 Kurzanleitung Seite 7

A
On the Date/Time Settings
screen select your local time
zone. Then set the current date
and time. Click Next.
B
Review the Network Storage
Link's settings. If they are
correct, click Save. If you would
like to change them, click Back
to return to a previous screen.
C
A screen will appear and ask
you to confirm that you want to
save new settings. To save
these changes, click OK, or
click Cancel to return to the
previous screen.
D
If the USB hard disk drive was
not previously used with a
Network Storage Link, then its
format must be changed. The
message shown in Figure I will
be displayed. To change the
USB hard disk drive's format so
that it can be used in the
Network Storage Link, click OK.
To leave the USB hard disk drive
unchanged, click Cancel, and
you will not be able to store
data on the hard disk drive.
IMPORTANT:The Network Storage
Link's format is NOT compatible with
Windows. You cannot swap USB hard
disk drives between Windows systems
and Network Storage Links.
F
G
H
I
7