Operation And Maintenance; Technical Parameters - Graphite 59G346 Betriebsanleitung

WHEEL FOR SPINDLE ROTATIONAL SPEED CONTROL
Orbital sander allows for operation with different spindle speeds. It can be controlled with the wheel for speed control (6) (fig. E).
● Turn the wheel for speed control (
● Turn the wheel for speed control (
Choose proper rotational speed when the orbital sander operates with no load, and with switch lock button pressed.
Defined speed may decrease under load.
ORBITAL SANDER OPERATION
● Whole area of backing pad must rest on the processed surface.
● Turn the sander on and apply moderate pressure; move it on the processed material in circular movements, in transverse
or lengthwise direction.
● For coarse processing use sanding paper with coarse grain, for finishing processing use fine-grained paper. It is best to
match the type of sanding paper by trials and errors.
● When finishing polishing, reduce pressure, lift the sander above the processed surface and only after that switch the tool off.
Unplug the power cord from the mains socket before commencing any activities related to installation, adjustment,
repair or maintenance.
● Always keep the sander clean.
● Remember to always keep the ventilation holes of the sander casing pervious.
● Never use any caustic agents for cleaning plastic parts.
● In case of excessive commutator sparking check technical condition of carbon brushes of the motor.
REPLACEMENT OF BACKING PAD
When replacement of the backing pad with another one is necessary, or when backing pad is damaged:
● Unscrew four screws that fix the backing pad (
● Remove and replace the backing pad.
● Screw the fixing screws.
REPLACEMENT OF CARBON BRUSHES
Replace immediately used up (shorter than 5 mm), burnt or cracked motor carbon brushes. Always replace both
brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be used.
Any faults should be repaired by service workshop authorized by TOPEX
RATED PARAMETERS
Parameter
Supply voltage
Current frequency
Rated power
Range of spindle rotational speed without load
Backing pad diameter
Diameter of sanding paper
Protection class
Weight
Year of production
6) clockwise to increase the speed.
6) counter-clockwise to reduce the speed.

OPERATION AND MAINTENANCE

8).

TECHNICAL PARAMETERS

Orbital Sander
12
Value
230 V AC
50 Hz
450 W
4000 – 13000 rpm
125 mm / 150 mm
125 mm / 150 mm
II
2.6 kg
2008