1.
First, loosen the screws on both sides and remove
the cover.
2.
Disconnect the power and HDD Signal cable from
the existing HDDs, then loosen the screws (x4) in
the left/right and upper sides and remove the upper
brackets.
3.
Install a HDD (x1) on the lower bracket and fi x it
with screws.
Firmly secure the screw so that it does not become
loose from vibration.
4.
Install HDDs (x3) on the upper bracket and fi x them
with screws.
5.
When the installation of additional HDDs is done,
insert the lower and upper brackets into the DVR
and fi x them with the provided screws.
6_ English
Z6809133101A_SRD-850DC-QG_ENGLIS6 6
Z6809133101A_SRD-850DC-QG_ENGLIS6 6
Cover
Upper Bracket
Lower Bracket
Upper Bracket
Lower
Bracket
2010-07-13 오전 9:32:25
2010-07-13 오전 9:32:25