ASROCK K7VM3 Schnellstart Handbuch Seite 9

FID Jumpers
(FID0, FID1, FID2, FID3, FID4)
(see p.2 item 2)
Note: The set of FID jumpers are designed to adjust the multiplier of CPU. For detailed
information, please refer to page 14 of user Manual in the Support CD.
CLRCMOS1
(see p.2 item 13)
solder points
Note: CLRCMOS1 and CLRCMOS2 allow you to clear the data in CMOS. The data in
CMOS includes system setup information such as system password, date,
time, and system setup parameters. There are 2 ways for you to clear and
reset the system parameters to the default setup. Please turn off the com-
puter and unplug the power cord, then you may either short the solder points
on CLRCMOS1 by using metal material, e.g., a paper clip, for 3 seconds;
or you may use a jumper cap to short the pin on CLRCMOS2 for 3 seconds.
Please remember to remove the paper clip or the jumper cap after clearing
the CMOS.
ASRock K7VM3 Motherboard
Clear CMOS
CLRCMOS2
(see p.2 item 18)
2-pin jumper
9 9 9 9 9