ASROCK K7VM3 Schnellstart Handbuch Seite 7

2.2 Installation of Memory Modules (DIMM) 2.2 Installation of Memory Modules (DIMM) 2.2 Installation of Memory Modules (DIMM) 2.2 Installation of Memory Modules (DIMM) 2.2 Installation of Memory Modules (DIMM)
This motherboard provides two 184-pin DDR (Double Data Rate) DIMM slots.
Installing a DIMM Installing a DIMM Installing a DIMM
Installing a DIMM Installing a DIMM
Step 1. Unlock a DIMM slot by pressing the retaining clips outward.
Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the
break on the slot.
Step 3. Firmly insert the DIMM into the slot until the retaining clip snap back in
place and the DIMM is properly seated.
2.3 Expansion Slots (PCI, AMR, and AGP Slots) 2.3 Expansion Slots (PCI, AMR, and AGP Slots)
2.3 Expansion Slots (PCI, AMR, and AGP Slots) 2.3 Expansion Slots (PCI, AMR, and AGP Slots) 2.3 Expansion Slots (PCI, AMR, and AGP Slots)
There are 2 PCI slots, 1 AMR slot, and 1 AGP slot on this motherboard.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AMR slot: AMR slot is used to insert AMR modem card with v.92 Modem
functionality.
AGP slot: The AGP slot is used to install a graphics card.
The ASRock AGP slot has a special locking mechanism which
can securely fasten the graphics card inserted.
DO NOT use 3.3V AGP card on K7VM3's AGP slot!
It may cause permanent damage!
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
Step 1. Before installing the expansion card, read the documentation of the
expansion card and make necessary hardware settings for the card.
Step 2. Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
Step 3. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 4. Fasten the card to the chassis with screws.
ASRock K7VM3 Motherboard
7 7 7 7 7