Technical Data; Troubleshooting - BOMANN MWG 2211 U CB Bedienungsanleitung

CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window.
The surface could be scratched and the glass could possibly
break.
Interior
• Keep the interior of the oven clean. Splashes and overflowing
liquids on the walls of the oven can be removed with a damp
cloth. If the oven is very dirty a mild detergent can also be
used. Please do not use any abrasive detergents.
• Wipe off the viewing window on the inside and outside with a
damp cloth and remove splashes and stains from overflowing
liquids regularly.
External Walls
• The external walls of the microwave should only be cleaned
with a damp cloth. Please ensure that no water enters the
openings in the housing and therefore inside the device.
• The switches should also only be cleaned with a damp cloth.
In order to clean the function switch, first open the microwave
door to avoid switching on the device so accidentally.
Accessories
• The glass plate should occasionally be cleaned with washing-
up liquid or in the dishwasher.
• The rotating ring and the inside floor of the oven should be
cleaned regularly. The rotating ring can be removed and
cleaned by hand. You may use a mild detergent or window
cleaner for this. Please dry thoroughly afterwards. Ensure that
the ring is put back in the correct position afterwards.
Odours
• In order to remove any unpleasant odours that may emanate
from the microwave, place a dish filled with water and lemon
juice that is suitable for microwave use in the oven and heat
it for approximately 5 minutes. Then wipe out the oven with a
soft cloth.
Oven light
• If you need to replace the lighting in the oven, please contact
a specialist workshop near you.

Troubleshooting

Malfunctions are often just caused due to minor problems. Before
contacting our customer service, please check the table below:
Fault Possible Cause
Radio or TV The electromagnetic
reception is fields of this device
interrupted dur- might interfere with
ing microwave the pictures and
operation. sound of special
frequencies.
48
Fault
The device is
not supplied with
electricity.
The display
shows "0:00"
The device does
not start opera-
tion. The display
shows a readout
other than the
current time.
All controls are
locked
The turntable
causes a scratch-
ing or abradant
noise.
The operation is
terminated with-
out any obvious
reason.
Model: ...................................................................MWG 2211 U CB
Power supply: ............................................................230 V~, 50 Hz
Power consumption:
Rated microwave power output: ..........................800 W/2450 MHz
Cavity volume: ...................................................................... 20 Liter
Protection class: ...............................................................................Ι
Net weight: ........................................................... ............... 12.5 kg
The right to make technical and design modifications in the
course of continuous product development remains reserved.
This device has been tested according to all relevant current CE
Notes/ Remedy
guidelines, such as electromagnetic compatibility and low volt-
This is normal and not
age directives, and has been constructed in accordance with the
a malfunction. Posi-
latest safety regulations.
tion the devices further
away from each other.
Possible Cause
Faulty mains socket •
There was a power
failure.
The door is not
properly closed
The QUICK START/
START button was
not pressed after
selecting the func-
tion.
The child-proof lock
is activated.
The time and "clock"
symbol are shown in
the display.
There are dirt or
foreign objects in the
area of the turntable
shaft.
The device is bro-
ken.

Technical Data

microwave: ...............................................................1250 W
grill: ............................................................................1000 W
Notes/ Remedy
Try another socket.
• Check the house
fuse.
Set the clock again.
Check if there are
objects or food remains
jammed in the door.
Press the QUICK
START/START button,
or press the CANCEL/
STOP button to cancel
the function.
Press and hold the
CANCEL/STOP button
for more than 3 sec-
onds to unlock.
The time-delay function
is activated. Press the
CLOCK/PRE-SET but-
ton to display the start
time. Press CANCEL/
STOP button to termi-
nate the function.
Remove possible ob-
jects and food remains
as described under
"Cleaning".
Please contact our
service department.
...