User Interface; Manual Mode; Cleaning And Maintenance; Routine Maintenance - Bartscher HI LITE Bedienungsanleitung

ENG
4.3 USER INTERFACE
On/off button; when the appliance is switched off all the functions are
switched off as well.
This button allows you to start or stop cooking and hold modes;
This button allows you to select either cooking or hold modes in case of
manual cooking; in case of program selection you can pass from cooking
mode to hold mode and viceversa;
these buttons increase or decrease cooking time and/or heat intensity of
the hold mode
This button allows you to set the cooking session with all resistances or just
the central resistances;
These buttons cannot be used when the appliance is in START mode; thus
the following instructions only refer to ON or STOP mode; you can select
a program by briefly pressing the corresponding button. You can enter the
program selection mode by holding down the button; you can then save
current settings and go back to normal functioning by briefly pressing the
same button again;
4 MANUAL MODE
Switch on the salamander by pressing the ON/OFF button
Press the Mode seleCt button to select the type of mode (cooking or hold – the
corresponding LED above the display will come on)
set time and intensity and then press staRt or place the plate on the plate detection
device to start the session (cooking mode will terminate once the time set ends and a
buzzer will sound); pressing the START/STOP button or removing the plate (the plate
detection device switches appliance off) will cause the HOLD mode to switch off.
20
AUTOMATIC MODE
Switch on the salamander by pressing the ON/OFF button
select the desired program by pressing the P1 or P2 or P3 button
Press staRt or place the plate on the plate detection device as in the manual mode.
SETTING A PROGRAM
Switch on the appliance by pressing the ON/OFF button
Hold down the desired program button (P1 or P2 or P3) until the display starts flashing
set the cooking or hold mode by pressing the seleCt/Mode button, then set the time
using the + and - buttons
if the cooking mode has been selected it is possible to set a hold mode session at the
end of the cooking session by pressing the seleCt/Mode button immediately after
setting the time and then setting the heat intensity from 1 to 8. you can save the
program by pressing the button again. If you press the program button again without
setting a hold mode session first, the cooking session only will be saved.
SWITCHING OFF
After use switch off appliance using ON/OFF switch and omnipolar switch upstream of
appliance.
5.

CLEANING AND MAINTENANCE

5.1

ROUTINE MAINTENANCE

At the end of each working day the unit must be cleaned both for reasons of hygiene
as well as to prevent malfunctions.
disconnect the unit from the electricity supply before starting.
Clean all stainless steel parts with warm, soapy water, rinse thoroughly and dry with
care. do not use products containing chlorine (e.g. bleach).
Do not clean the unit with jets of water or high pressure water. Do not use metal
cleaning pads, brushes or scrapers made of ordinary steel. if necessary, use stainless
steel wool, rubbing in the direction of the satin finish.
if the unit is left unused for any length of time, apply a thin protective layer of Vaseline
oil over all stainless steel parts with a cloth; ensure that the room is regularly aired
as well.
ENG
21