Intended Use; Unpacking Your Tool; Before Use; Operation - GMC GPM1600 Bedienungsanleitung

Intended Use

Handheld electric 2-speed paddle mixer used for the preparation of
plaster, cement, levelling compounds, emulsions and similar building
and decorating materials.

Unpacking Your Tool

• Carefully unpack and inspect your new sander. Familiarise yourself
with all its features and functions
• Ensure that all parts of the tool are present and in good condition.
GB
If any parts are missing or damaged, have such parts replaced
before attempting to use this tool

Before Use

WARNING: Ensure the tool is disconnected from the power supply
before attaching or changing any accessories, or making any
adjustments.
Attaching a mixing paddle
WARNING: Always disconnect from the power supply before
attaching/changing accessories.
WARNING: Never fit any attachment with a maximum speed lower
than the no load speed of the machine.
• This plaster mixer is equipped with an M14 female Output Drive (3)
• M14 threaded mixing paddles are fitted by screwing them into the
output drive. Tighten with a suitable spanner
• Ensure that the mixing paddle is securely tightened before use

Operation

WARNING: ALWAYS wear eye protection, adequate respiratory and
hearing protection, as well as suitable gloves, when working with this
tool.
Switching On and Off
WARNING: Always ensure that the power cord is not interfering with
the mixing paddle or presenting a tripping hazard for the operator or
other personnel in the vicinity.
• Grip the mixer firmly by the Handles (4), with both hands
• To start the mixer, squeeze the On/Off Trigger Switch (5)
• Press the Lock-On Button (6) to lock the tool in the 'on' position
• To stop the mixer, squeeze the On/Off Trigger Switch and release
Speed selection
• The mixer is fitted with a 2-speed gear box and variable speed
control
• Slide the Gear Selector Switch (9) up or down, to select high or low
gear
WARNING: The Gear Selector Switch must ONLY be operated when
the mixing paddle has stopped rotating. NEVER operate the Gear
Selector Switch when the machine is running, as this would cause
damage to the gear box.
• To alter the speed, simply adjust the Variable Speed Dial (8). The
higher the number, the faster the speed
Mixing of material
WARNING: ALWAYS wear adequate personal protection equipment
when mixing compounds, including safety goggles or a face shield,
breathing protection (specific to the material used), gloves (suitable for
the material used), hearing protection, and a hard hat where required.
WARNING: This tool is designed for two-handed operation. Never
use with one hand, or attempt to mount stationary or prop-up against
another object.
Note: ALWAYS refer to the compound manufacturers mixing
requirements and recommendations.
• The shape and size of a mixing paddle that is ideal for a specific
application will depend on the type of material being mixed:
- Substances with a low viscosity such as dispersion paint, varnish,
thinset, sealing and levelling compounds, cement, grout etc., will
require a mixing paddle with a left-hand twist
- Substances with a high viscosity, such as ready-mixed plaster,
concrete, screed, putty and epoxy resin, will require a mixing
paddle with a right hand twist
• It is important to keep the paddle moving throughout the bulk of
the material whilst mixing, as opposed to keeping it in one central
position in the mixing container. Mix until compound is completely
blended
WARNING: DO NOT overload the motor whilst mixing. When you
recognise a significant drop in speed, switch off immediately to avoid
damage to the tool. Consider changing to a different mixing paddle or
accessory more suitable for the material.
WARNING: When you have completed the mixing procedure, allow
the mixer to come to a complete stop before lifting it out of the
material. Make sure not to contaminate the environment and clean-up
potential spillage.
WARNING: To avoid damage to the machine and cross-contamination
between different materials, always clean the mixing paddle
immediately after use. Don't let the material dry on the accessory.
Also, refer to the paragraph 'Cleaning' in the 'Maintenance' section
below.
10