Inhaltsverzeichnis
Werbung
GB
44
ANGLE POLISHER
The numbers in the following text refer to the
drawing on page 2 - 4.
Read this operators guide carefully,
before using the machine. Ensure that
you know how the machine works, and
how it should be operated. Maintain the
machine in accordance with the
instructions, and make certain that the
machine functions correctly. Keep this
operator's guide and other enclosed
documentation with the machine.
Contents
1. Machine data
2. Safety instructions
3. Assembly
4. Use
5. Service & maintenance
Introduction
The hand held electric polisher is suitable for
non-professional use. Any other use other than
polishing and light sanding is strictly forbidden.
1. MACHINE DATA
Technical specification
Voltage
Frequency
Power input
No-load speed
Disc diameter
Spindle dimension
Weight
Lpa (sound pressure)
Lwa (sound power)
Vibration value
Contents of packing
1
Angle polisher
1
U-shaped handle
1
Hexagon key
1
Instruction manual
1
Safety instructions
1
Warranty card
Check the machine, loose parts and accessories
for transport damage.
Ferm
Ferm
Features
Fig. 1
1. On/off switch
2. Speed controle
3. U-shaped handle
4. Pad holder
5. Spindle lock
6. Switch lock
2. SAFETY INSTRUCTIONS
The following symbols are used in these
instructions for use:
Denotes risk of personal injury, loss of
life or damage to the machine in case
of non-observance of the instructions in
this manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the
mains electricity in the case that the
cord gets damaged and during
maintenance
Keep bystanders away
Wear ear and eye protection
230 V~
50 Hz
Special safety instructions
1400 W
•
Check that the maximum speed indicated on
0 - 3000/min
the disc corresponds to the maximum speed
180 mm
of the machine. The speed of the machine
M 14
must not exceed the value on the disc.
3.4 kg
•
Make sure that the dimensions of the disc
89 dB (A)
correspond to the specifications of the
100 dB (A)
machine.
8.69 m/s
2
•
Make sure that the disc has been mounted
and fastened properly. Do not use reducing
rings or adapters to make the disc fit properly.
•
Never use this machine single handed.
Always use both hands to operate the
machine.
•
Do not touch any rotating parts.
•
Make sure the wool bonnet is not contacting
the workpiece before the machine is switched
on.
•
Do not touch the workpiece immediately after
operation. It may be hot.
GB
05
Werbung
Inhaltsverzeichnis
