Operating Instructions - Starrett 2900 series Handbuch

OPERATING INSTRUCTIONS

1. First read the "New battery, Startup Sequence"
section below, and the "Zero Sequence" on the
next page 11.
2. Install the batteries that came with the indicator.
Refer to "Battery Drawer Removal" and "Battery
Replacement" on pages 25, 26.
3. Lightly clean the contact point.
4. Fasten the indicator onto the appropriate holding device.
5. You can turn the indicator on by either pressing
the ON/OFF button or moving the spindle.
6. If applicable, pick the unit of measure, inch or
millimeter by pressing the IN/mm button.
Note; standard metric indicators do not have this
function available, however this will be available
on the ME series of indicators.
7. Place the indicator perpendicular to the reference
surface being measured. Allow enough movement
to be able to take a higher or lower measurement.
8. Reset the display by pressing the ZERO Button.
9. Lift the spindle to remove the reference surface,
and carefully place the piece to be measured under
the spindle making contact with the surface. The
value measured on the display will be the difference
between the reference and the measured piece.
10. The indicator can be turned off by pressing and
holding the ON/OFF button for 3 seconds.
Note: the unit will automatically enter sleep mode in
30 minutes, if left unattended.
ENGLISH
PKG08803-UM2900 9