Pentair Foleo 5800 XTR Benutzeranleitung Seite 13


7. Backwash
Rapid Rinse
8.
Treatment
9.
10. Day and time
11. Next scheduled
regeneration
Tank Refill
12.
13. 
Pause
Draw
14.
Custom
15.
16. Home
17. USB connect
Arrows
18.
Note

Settings on previous screen are not saved unless
19. Alarm
20. Error
21. Error log
22. Advance
Reset
23.

Ref. MKT-UG-038 / D - 15.11.2019
→ Water flows from the bottom of the vessel to the top of the vessel to clean and mix the
media.
→ Water flows from the top of the vessel to the bottom of the vessel to rinse the media.
→ The unit is treating water.
→ Displays the currently programmed day of the week and time. This button will flash at the
start-up and if the supercapacitor is discharged
→ Displays the time to next scheduled regeneration, or volume remaining until regeneration
in meter systems.
→ Brine tank is refilled with water.
→ Valve comes back in service position to allow brine preparation after refill. Shown if
variable refill/brining regeneration flow has been selected in master setting.
→ Brine is drawn into the media and then slowly rinsed out.
→ Shown if custom regeneration flow has been selected in master setting.
→ Displays the home screen.
→ Allows you to connect the controller to a PC via a USB cable for field programming or
download of diagnostic parameters via PC (Field Programmer application required).
→ Displayed in the upper-left and upper-right corners of the screen, these arrows allow you
to navigate from one screen to another.
→ Allow you to change the values of certain settings when programming the controller.
→ Displayed when an error has occurred; accompanied with an audible alarm. Press to
silence the audible alarm.
→ Displayed when an error has occurred. Press to display the error screen for more
detailed error information.
→ Press to show error list with date and time.
→ This arrow allows you to advance through cycle steps during a regeneration.
→ Displayed in the diagnostics screen by pushing on totalizer and peak flow buttons to reset
totalizer and peak flow data, and in master settings screen to reset parameters to factory
or non-factory settings.
is pressed.
User Guide Foleo
13 / 116