Pentair Foleo 5800 XTR Benutzeranleitung Seite 12

User Guide Foleo
5 . Programming
5.1. Home screen & commands
Note

If no button is pushed for five minutes, the screen will enter a power save mode. The unit will continue
to operate, but the screen will be blank. Touch anywhere on the screen to exit power save mode.
Note

Not all buttons appear on all screens.
1. Regeneration
Settings
2.
3. Diagnostics
4. Assistance
5. Vacation

6. Regeneration
cycle wheel
Note

On metered units, the "Treatment" step on the regeneration cycle wheel will flash when water is
flowing through the unit.
12 / 116
Water Treatment
wed
12:01 am
rapid rinse
backwash
→ Displays the regeneration screen, which allows you to start a regeneration and manually
cycle through the regeneration steps.
→ Displays the settings screen, which allows you to adjust commonly used settings.
Pressing this button while in the settings screen provides access to the master settings
screen, which allows you to fully program the valve.
→ Displays the diagnostics screen, which can assist in performing maintenance and
troubleshooting performance issues with the valve.
→ Displays a name and phone number to call for unit service.
→ Halts all scheduled regenerations when pressed; press again to resume normal
operation.
→ Displays the cycle steps the valve will step through during service and regeneration; the
current cycle step is always shown on green.
treatment
tank refill
pause
draw
4.5
3
m
Ref. MKT-UG-038 / D - 15.11.2019