Orbis ANRET Q-R Bedienungsanleitung Seite 65

Note: if the voltage V or the current I are >999, the words "Voltage"
and/or "Current" will flash to indicate that the measurement unit
is not complete (the prefixes 'k' or 'M' are missing)
3) Phase voltage page
VOLTAGE
1
3
The phase voltages are displayed.
If the three phase system has no neutral, the voltages refer to a fictitious
star delta centre
Press "T" to display the system voltage page
3a) Phase voltage peak value page
VOLTAGE
V
V
1
3 2
If the "pK" is pressed repeatedly from one of the two phase voltage pages,
the following are displayed in order:
- the voltage peak values (phase or system), with the "V" measurement
unit flashing
- the instant when the peak occurred (time and date flashing if the clock
has not yet been set)
- the number of hours lapsed between the start-up of the instrument
and the occurrence of the peak, in hours and tenths of one hour
Press "up" ( ) at any time to go to the next page
VOLTAGE
V
2
T
pK
VOLTAGE
- 63 -
User's Manual - ANRET Q-R / M-R
pK
V
pK
h
VOLTAGE
pK
h
T