Orbis ANRET Q-R Bedienungsanleitung Seite 56

Scroll to the next page and parameter setting
Scroll to the previous page and parameter setting
T
Display of the system values
Display of the peak values to be measured and selection
pK
of the parameters in the programming stage
First installation programming
To gain access to the first installation programming menu, the instrument
has to be powered by holding down the "up" ( ) and "down" ( ) keys
together until the display is lit up
The parameters that can be programmed by the user are the following, in order:
Primary TV (fixed secondary 230 V)
Primary TA (fixed secondary 5 A)
For a new parameter setting, the instrument should be switched off then on
again by holding down the "up" ( ) and "down" ( ) keys together until the
display is lit up
Important
: before switching the instrument off, disconnect the
measurement (current and voltage)
TV setting
VOLTAGE
Press the "up" ( ) or "down" ( ) keys to select the required value of the
KEYS
SETTING THE PARAMETERS
pK
v
- 54 -
User's Manual - ANRET Q-R / M-R
VOLTAGE
v
T