Orbis ANRET Q-R Bedienungsanleitung Seite 64

1) Relay status page
1
2
1b) Relay switching page
1
2
Press the "pK" repeatedly from the relay status page to display the following,
in order:
- the instant when the last switching operation took place on the relay indicated
(press "T" to move from one relay to another), expressed in time and date
- the number of hours that has lapsed from the last reset of the instrument
and the switching operation, expressed in hours and tenths of an hour
Press the "up" key ( ) at any time to go to the next page
Note: when "pK" and "T" are pressed and held down together
for 3 seconds, the switching of both relays is forced for approximately
30 seconds (or a 100 ms impulse is forced if the relays are set as
"consumption indicators"). This status is confirmed by the complete
lighting up of the central symbol in the display.
2) Overall page
k W
V A
pK
1
- 62 -
User's Manual - ANRET Q-R / M-R
The status of the two relays is
displayed ("ON" or "OFF")
pK
h
The system voltage and current and
the active system power rating are
displayed
Press "pK" to display the value set
for the TA primary.
Press "T" to display the value set for
the TV primary
pK
h
1
T