Troubleshooting - cecotec FORCECLIMA 7050 Bedienungsanleitung

UNIT STORAGE
• Unscrew the drainage cover, remove the water lid and empty the water in the water tray
into other water containers or directly tilt the body to discharge the water into other
containers.
• Turn on the machine, adjust it to low-wind ventilation mode, and maintain this state
until the drainage pipe dries, so as to keep the inside of the body dry and prevent it from
mildewing.
• Turn off the machine, unplug ir from the power supply, and wrap the power cord. Install
the water lid and the drainage cover.
• Remove the exhaust pipe and store it properly.
• Cover the local air conditioner with a plastic bag. Put the local air conditioner in a dry
place, keep it out of the reach of children, and take dust control measures.
• Remove batteries from the remote control and keep them properly.
NOTES: ensure that the body is placed in a dry place and store all machine components
properly.

6. TROUBLESHOOTING

Do not repair or disassemble the local air conditioner by yourself. Unqualified repair will lead to
failure of the warranty, and may cause damage to users or their properties.
Problems
The local air
conditioner
does not work.
The cooling
effect is not
good.
05244_FORCECLIMA 7000_Manual_LI_MV.indd 27
Reasons
There is no electricity.
The overflow indicator displays
"FL".
The ambient temperature is too
low or too high.
In cooling mode, the room
temperature is lower than the set
temperature.
In dehumidification mode, the
room temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources of
heat.
The filter screen is dirty.
The air inlet or outlet is blocked.
Solutions
Turn it on after connecting it to a socket with
electricity.
Discharge the water inside.
It is recommended to use the device in a
temperature range of 7-35 ºC (44-95 ºF).
Change the set temperature.
Place the product in a room where the
temperature is over 17 ºC (62 ºF).
Avoid direct sunlight by using curtains, for
example.
Close doors and windows, and restart the
local air conditioner.
Clean or replace the filter screen.
Clear obstructions.
FORCECLIMA 7050
ENGLISH
27
19/12/18 12:51