Network Components For A Windows Ad-Hoc (Peer-To-Peer) Network Installation; Procedure For A Windows Ad-Hoc (Peer-To-Peer) Network Installation - HP LaserJet 1022nw Leitfaden Zur Inbetriebnahme

Network components for a Windows ad-hoc (peer-to-peer)
network installation
You will need the following components to perform an ad-hoc installation:
1 Functioning ad-hoc wireless network
2 HP LaserJet 1022nw Wireless Printer Getting Started Guide (this document)
3 CD-ROM containing the installation software and the HP LaserJet 1022nw Wireless Printer User
Guide
4 Power cord
Procedure for a Windows ad-hoc (peer-to-peer) network
installation
Please read the entire procedure before starting an ad-hoc wireless network installation. For
best results, follow the instructions in the order listed.
HP highly recommends that you have an existing ad-hoc network or that you configure one
NOTE
before starting this installation method.
1. Preparing the printer
a. Close all applications on your computer.
b. Plug the printer into a power outlet and turn the printer on.
c. Wait a few minutes and then print a configuration page. When the printer is in the
d. If the IP address on the configuration page is 0.0.0.0, then wait a few minutes and
ENWW
Ready state, press and hold the
repeat the previous step. Do this until the IP address is not 0.0.0.0. The printer will
have an IP address based on your personal network configuration. For example, the
IP address might look like 192.168.x.y, where the x and y can be any numbers
between 0 and 255.
G button until the Ready light starts blinking.
O
Connect the printer to a wireless only network 19