Bosch Ciso 3600 H55 Serie Bedienungsanleitung Seite 48

OBJ_BUCH-894-001.book Page 48 Tuesday, November 25, 2008 2:22 PM
48 | English
Engage the safety lock 7 by moving the button as
shown.
Using a 5 mm hex wrench socket key (not provided) to
remove the blade screw 10 which secures the blade.
Remove spacer 11.
Remove the blade 2 as shown. Be careful not to al-
low any foreign matter to become attached to the blade
gear and do not damage it.
Insert blade 2 as shown. Ensure that the blade 2 has
located in the transmission link 12.
Rotate the blade 2 to the fully open postion. Check the
blade 2 location by gently pulling. If the blade 2 is correct-
ly located then blade cannot be removed.
Incorrect location of the blade will damage the ma-
chine.
Refit spacer 11. Ensure spacer 11 is located through
fixed blade and moving blade.
Refit the blade screw 10 and tighten it by using a 5 mm
hex wrench socket key (not provided). Do not overtight-
en.
Ensure replacement parts fitted are Bosch approved.
After Pruning/Storage
Warning! Switch off and engage the safety lock 7.
Always wear protective gloves when using, adjusting
or cleaning the machine.
Clean the exterior of the machine thoroughly using a soft
brush and cloth. Do not use water, solvents or polishes.
Remove all debris.
F 016 L70 560 | (25.11.08) Bosch Power Tools