Network Settings; Closed Caption Language Settings; Software Update - Sony STWA-C101 Bedienungsanleitung

Network Settings

In the "Network Settings" menu, you can set the following settings. After selecting the settings,
click the "Apply and Restart system" button to save the changes you made and restart the unit.
It takes about one minute for the unit to restart.
Setting item
IP Address
Gateway
Subnet Mask
DCS IP Address
Closed Caption Language
Settings
In the "Closed Caption Language Settings"
menu, you can select up to six languages
from which the users of the captioning
glasses can choose to display the closed
captions. After selecting the language(s),
click the "Apply and Restart system" button
to save the changes you made and restart the
unit. It takes about one minute for the unit to
restart.
Note
If the DCP (Digital Cinema Package) does not
contain closed caption data for the selected
language(s), then no caption data for the
language(s) is transmitted.
Tip
You can select "any Auto-select" in the
language selection. In this case, the default
language is automatically displayed from the
DCP's closed captions.
Standby Message
You can enter a message that is transmitted
to the receiver when the D-Cinema server is
not playing the DCP that contains closed
captions. You can enter from 2 to 20
characters for the message and can use only
characters supported by the receiver.
RF Power
For service use only. Do not change the
setting.
14
GB
Function
Sets the IP address of the unit. The default setting is "192.168.10.100."
Sets the default gateway IP address.
Sets the subnet mask of the network. The default setting is "255.255.255.0."
Sets the D-Cinema server IP address. The default setting is "192.168.10.101."
Test Mode
For service use only. Do not change the
setting.

Software Update

You can update the software of the unit by
following the instructions below.
1
Store the update file in your computer.
You can download the file from the
Digital Cinema web site. Contact your
Sony sales representative for the URL of
the web site.
2
Open the setting screen of the unit.
3
Click "Update" in the "Software
Update" box at the bottom of the
screen.
4
Click "Browse..." to open the file
selection dialog box.
5
Choose the file downloaded in step 1
and click "OK."
6
Click "Submit and Restart system" to
update the software.
It takes about 30 minutes to complete the
update.
To prevent possible unit malfunctions
Never turn off the unit during the update
process. It may cause a malfunction.