Battery And Charger; Battery And Charger Safety Rules; Battery Charger Operation - Alemite 596-Serie Benutzer- Und Wartungsanleitung

Battery and
charger

Battery and charger

safety rules
This manual contains important safety and
operating instructions for battery part num-
ber 343291 and battery chargers 343500
and 343501.
WARNING

Before using battery charger read all
instructions and cautionary markings
on battery charger (53), battery (39),
and products using battery.
An extension cord should not be used
unless absolutely necessary. Use of an
improper extension cord could result in
a risk of fire and electric shock. If an
extension cord must be used, make sure
it is 18- gauge. Check to ensure that
pins on plug of extension cord are same
number, size, and shape as those of plug
on charger. Make sure that extension
cord is properly wired and in good elec-
trical condition.
Do not incinerate battery, even if it is
severely damaged or completely worn
out. Battery may explode in fire.
If supply cord is damaged it must be
replaced by manufacturer, it's service
agent or similarly qualified persons in
order to avoid a hazard.
CAUTION

• Do not expose charger to rain, snow,
or frost.
• Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
• Do not operate charger with damaged
cord or plug. Replace immediately.
• Do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way.
• Do not disassemble charger.
• Charger is designed to operate on
standard household electrical power.
Do not attempt to use it on any other
voltage.
• Consecutive charging may cause
overheating. If you need to recharge
battery consecutively, wait for about
15 minutes to allow charger to cool.
• Do not insert foreign material into slot
for battery in charger stand.
• Do not disassemble battery.
• Do not store gun and battery assem-
bly in locations where temperature
may reach or exceed 104 °F (40 °C).
• Do not short-circuit battery.
• Do not place charger in an area of
extreme heat or cold. It works best at
normal room temperature.
12
Battery charger
operation
Charge the battery only with the charger
provided or optional mobile charger 343289.
Make sure power circuit voltage is same as
that shown on the charger specifications
plate. Ensure the battery properly engages
with the charger's contacts.
The battery will become slightly warm to
the touch while charging. This is normal and
does not indicate a problem.
Leaving battery in charger
Battery can be left connected in charger with
green LED glowing indefinitely. Charger will
keep battery fresh and fully charged.
Charger features an automatic tune-up
mode which equals or balances individual
cells within battery to enable it to function at
peak capacity. Batteries should be tuned-up
weekly or whenever battery no longer deliv-
ers same amount of work. To use automatic
tune-up mode, place battery in charger for a
minimum of 8 hours.