Herunterladen Inhalt Inhalt Diese Seite drucken

Operation - Ribiland PRW500A Bedienungs- Und Wartungsanleitung

Elektrischer rasentrimmer 450 w
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 21
ADJUSTMENTS
This lawn trimmer can be converted into cut the
edges of lawns and flower beds.
°
1. Disconnect the lawn trimmer from the mains.
60
2. Press the edging conversion button (8) and at the
same time turn the upper handle (2) clockwise
through a 180° degree until it latches in place.
Release the edging conversion button (8).
3. The lawn trimmer has now been converted into
an edger suitable for vertical cutting along the edge.
Fig. 9
To adjust the head up-or-down by a 60° degree, press
on the release footplate. Adding adjustable height of
the flex-tube to fit different statures
Warning: Take extra care when using this lawn trimmer as an edger. Keep away from the line of
rotation to avoid any flying particles that may result from edging. This lawn trimmer is designed to
maintain existing edges. It should not be used to create edges. Edges can be created using an edging
spade
SWITCH
To operate product: press on the safety switch (5) then press on the On/Off trigger switch (4).
To stop product: release the On/Off trigger switch (4)
V. OPERATION
Intended use
- The product is intended for domestic use.
- The product is intended for cutting grass, mowing lawns; maintain edges or flower beds...

Operation:

1. Remove the blade protector on the line trimming blade prior to use.
2. Plug product to a power source
3. Wear appropriate protective equipment.
4. Firmly hold product to avoid kickbacks. Always maintain a balanced and secure position.
5. Place product on working area.
6. Press on safety switch (5) then press ON/OFF switch (4) to start operation.
7. Start operating on working area with slow left-to-right movement, working through small areas at
a time. Do not make sudden movements.
8. Never cut wet or very damp grass. Keep the trimmer away from hard surfaces.
9. Once work is finished, stop product by releasing the switch (4).
Note: do not put down product until cutting line has completely stopped rotating.
10. Replace the blade-protector after use

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis