Monacor AV-420SET Bedienungsanleitung Seite 9

charger or plug-in power supply unit from the mains
socket if
1. there is visible damage to one of the units,
2. a defect might have occurred after a drop or simi-
lar accident,
3. malfunctions occur.
The units must in any case be repaired by skilled
personnel.
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other purpos-
es than originally intended, if they are not correctly
connected, operated, or not repaired in an expert way.
If the units are to be put out of operation defi-
nitively, take them to a local recycling plant for
a disposal which is not harmful to the envi-
ronment.
3 Applications
The set of units AV-420SET consists of a 2.4 GHz wire-
less camera, the corresponding receiver, a charger for
the wireless camera, and a 12 V power supply unit for
the receiver. It serves for setting up a wireless video sur-
veillance system. For this purpose only a colour monitor
is additionally required. For the audio transmission a
microphone has been integrated into the colour camera.
The transmission range largely depends on the
local conditions. Without any obstacles between
camera and receiver it may be up to 100 m. However,
in buildings the range is reduced to approx. 20 m by
walls and ceilings, depending on their condition. By
using an antenna with gain at the receiver, the range
can, however, be increased many times over.
3.1 Conformity and Approval
Herewith, MONACOR INTERNATIONAL declare that
the set of units AV-420SET is in accordance with the
basic requirements and the other relevant regulations
of the directive 1995/5/EC. The declaration of confor-
mity can be found in the Internet via the MONACOR
INTERNATIONAL home page (www.monacor.com).
The set of units is licence-free and generally ap-
proved for operation in EU and EFTA countries.
4 Operation
4.1 Placing the camera and receiver
Practical experience has shown that an optimum
reception is achieved when placing the units at a height
of minimum 1.5 m to 2 m above the ground. Prior to the
final mounting, a trial run is recommended as the trans-
mission quality can substantially be changed by dis-
placing the camera and the receiver by a few centime-
tres only.
GB
9