LG 47WV30MS Installationsanleitung Seite 27

Setting the Picture ID
Picture ID is used to change the settings of a
specific set (display) using a single IR receiver for
multi-vision. The set receiving the IR signal com-
municates with another set via the RS232 connec-
tor. Each set is identified by a Set ID. If you as-
sign the Picture ID using the remote control, only
displays with the same Picture ID and Set ID can
be controlled remotely.
AUDIO
(RGB/DVI)
RS-232C OUT
RS-232C IN
REMOTE
CONTROL IN
IR Receiver
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
1
Press the ID On (Red) button on the remote con-
trol.
BACK
TILE
ID
ON OFF
2
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
Picture ID
Off
Close
EXIT
MULTIVISION CONFIGURATION
If you press the left/right buttons or press the
ON button repeatedly, the Picture ID cycles
through OFF and 1 to 4.Assign the ID you
want.
Picture ID
Off
Close
If you assign the Set ID to each set with
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
The maximum value of the Picture ID can be
set in the Total Set ID menu.
Please refer to the Installation Manual for
more information on the assignment of a
Total Set ID.
NOTE
For example, if the Picture ID is assigned to
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
For each set, you can change the settings
for the PICTURE, AUDIO, TIME, OPTION,
NETWORK and MY MEDIA menus or the hot
keys on the remote control.
If you press the ID OFF (Green) button, the
Picture IDs for all sets are turned off. If you
then press any button on the remote control,
all sets will start working again.
The Picture ID function may not work during
MY MEDIA operating.
27