AEG S74010KDWF Benutzerhandbuch Seite 21

Problem
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door does not open easily.
Possible cause
Food products prevent wa-
ter from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
Many food products were
stored at the same time.
The COOLMATIC function
is switched on.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open
the door immediately after
closing.
ENGLISH
Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Keep the NO REFERENCE TO
BUTTON MODE pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Refer to "COOLMATIC func-
tion".
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Wait a few seconds between
closing and re-opening of the
door.
21