Operation; Maintenance; Optional Accessories - Makita 9910 Bedienungsanleitung

Connecting to Makita vacuum
cleaner
► Fig.6: 1. Optional hose 28 mm in inner diameter
2. Hose of vacuum cleaner 3. Vacuum
cleaner
Cleaner sanding operations can be performed by con-
necting the belt sander to Makita vacuum cleaner.
When connecting to Makita vacuum cleaner, an optional
hose 28 mm in inner diameter is necessary.

OPERATION

Sanding operation
► Fig.7
CAUTION:
• The tool should not be in contact with the work-
piece surface when you turn the tool on or off.
Otherwise a poor sanding finish or damage of
the belt may result.
Hold the tool firmly with both hands. Turn the tool on
and wait until it attains full speed. Then gently place the
tool on the workpiece surface. Keep the belt flush with
the workpiece at all times and move the tool back and
forth.
Never force the tool. The weight of the tool applies ade-
quate pressure. Excessive pressure may cause stalling,
overheating of the motor, burning of the workpiece and
possible kickback.
Clamps (optional accessory)
This machine can be operated in the inverted position.
To do so, secure the machine to a stable workbench
with two clamps.
► Fig.8: 1. Clamps

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Replacing carbon brushes
► Fig.9: 1. Limit mark
Remove and check the carbon brushes regularly.
Replace them when they are worn down to the limit
mark. Keep the carbon brushes clean and free to slip in
the holders. Both carbon brushes should be replaced at
the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
► Fig.10: 1. Screwdriver 2. Brush holder cap
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Abrasive belts
• Dust bag
• Clamp
• Hose 28 mm in inner diameter
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
6 ENGLISH