Torque Adjustment - Rebel Rb-1000 Bedienungsanleitung

Installing hook
The hook is convenient for temporarily hanging the power tool for example on the tool
belt. It can be installed on either side of the power tool. To install the hook, place it on the
designated place on one of the sides of the power tool and secure it with a screw.

Torque adjustment

The torque can be adjusted in 18 steps. To set the desired torque rotate the adjusting ring
(2) right/left so that the appropriate number is opposite the arrow.
Set the torque adjusting ring to the
Speed range selection
The power tool has been equipped with the speed range switch (3). There are two ranges
available. To set the speed range, push the switch forward (2- higher speed) / backward
(1- lower speed).
Rotation direction adjustment
The power tool has been equipped with rotation direction switch (7):
• To achieve right rotation (driving in screws/drilling), push the rotation direction switch
(7) maximally left.
• To achieve left rotation (loosening screws), push the rotation direction switch (7)
maximally right.
Switching the power tool on and off
• Pressing the ON/OFF (5) switch will activate the power tool.
• Releasing the ON/OFF (5) switch will stop the power tool.
• Set the rotation direction switch (7) to the middle position to lock the movement of the
ON/OFF switch. It cannot be activated in this position.
Work light
Above the ON/OFF switch there is a work light (4). It turns on when the ON/OFF switch is
pressed. It turns off when the ON/OFF switch is released.
Warning: The work light is intended to illuminate the power tool's direct area of working
operation and is not suitable for other purposes. Do not look directly into the light. Risk
of eye damage!
Spindle lock function
The power tool is fitted with an automatic spindle lock feature. When the ON/OFF switch (5)
is not pressed, the chuck (1) rotation is locked. Now it is possible to use the drill (even when
the battery is empty) as a manual tool.
marking for drilling.
53 EN